Skip to content

Heat Pump Hot Water Jesmond

Heat pump hot water in Jesmond replaces an old electric cylinder with a unit that heats water for a fraction of the running cost. We size the system to the household, set it in the best position, and give you the full figure before any dismantling starts. Ring your plumber in Jesmond on (02) 4063 1093 or send the form.

An old cylinder is the expensive way to heat water. A heat pump works like a fridge in reverse, harvesting the warmth already in the outside air rather than paying to generate heat from scratch, and that is where the saving lives. The hot water hub walks the full repair-or-replace decision.

Licensed plumbers and gas fitters · NSW Lic. 359278C

Last updated September 2026

Storage hot water unit fitted against a house wall
Newly installed storage hot water unit

Why swap the old cylinder?

Three things usually trigger the changeover:

  • running costs climbing on an electric storage unit that struggles to keep up
  • a tank leaking or rusting, which no repair holds for long
  • a rental changing hands, where a reliable unit matters more than a patched one

The saving comes from the way the unit works rather than anything clever on the roof, which keeps the changeover straightforward.

Electric storage hot water unit after installation

The housing and the climate here

The conditions do heat pumps favours

Weather records for the area average a fraction of a frost day each year, and the main summer exposure is storms rather than cold snaps, so the unit is not working against the elements.

The housing decides the job

Older detached places and long-held rentals across the suburb frequently keep their hot water gear running long after it should have retired. At the last census, separate houses made up 46.3 per cent of dwellings and apartments 25.6 per cent, so the work ranges from a weatherboard backyard tank to a unit block's shared cylinder, and each place is quoted on what it needs.

What builds the heat pump quote?

The figure is built from:

  • the unit itself, type and capacity, matched to how many people live there rather than guessed
  • the position, since a straight swap at the old tank's spot costs less than a relocation
  • the removal and disposal of the cylinder that comes out
  • any plumbing changes the new position needs, quoted inside the one figure

Nothing gets added once you have agreed the number.

From old cylinder to running heat pump

  1. 01

    Ring or send the form

    Call (02) 4063 1093 or use the form to explain the fault. We ask enough to bring the right equipment the first time.

  2. 02

    A fixed price first

    A plumber inspects the job and names a fixed figure up front. Nothing gets started until you give the go-ahead.

  3. 03

    The swap itself

    The old cylinder is drained and lifted out, the heat pump tank goes into its position, and every connection is pressure-tested with the hot taps running before the unit is commissioned.

  4. 04

    Covered for a year

    Every job carries our 365-day warranty on all work. If something we did isn't right, ring the same number.

If the new unit has to arrive on a later truck, a temporary tank keeps the household in showers until it lands.

What Customers Say

[The plumber] & his young helper were courteous, well mannered & competent when replacing the solar hot water station pump at my property
Jennifer

When we're not the right call

A heat pump needing a new dedicated circuit is an electrician's job first, ours second. We handle the plumbing side, but the circuit work belongs with a licensed sparky, and the quote names that split plainly rather than pricing around it. An after-hours failure with no hot water at all is better served by the emergency plumber line, and a household already on gas may find a continuous-flow unit through gas appliance installation fits the pipework better.

Heat pump questions from around Jesmond

Does a heat pump cope with a Jesmond winter?

Yes. Frost barely rates a mention at this end of the Hunter, so the defrost cycle that drains heat pumps in colder towns almost never runs here, and winter running costs stay far below an old electric cylinder's.

Can a heat pump go where the old electric tank sat?

Usually yes. A heat pump tank can often take the old cylinder's spot, though it needs airflow around it, so a tight internal cupboard may not suit and an outside wall position is often better. We check the spot and the pipe run as part of the quote so there are no surprises.

What happens to hot water while the swap happens?

The changeover is planned so the new unit is ready before the old one is disconnected, and the swap itself is a day's plumbing work. If the system has to be ordered in, a temporary tank covers the hot taps until it lands, arranged before anything gets taken offline.

Do you quote before the old tank comes out?

Always. The quote covers the unit, the install and the disposal of the cylinder being removed, and you hear the whole figure before anything is disconnected. If the job turns up something unexpected once we are in there, we stop and requote rather than quietly adding it on.

Need a plumber? Call or send the form

Call (02) 4063 1093 or send the form below. Available 24/7, you see a fixed figure ahead of any work, and every job carries our 365-day warranty on all work.

Call (02) 4063 1093

Request a callback

Leave a name and number and a plumber will ring you back.

We use your details only to call you back about this job. See our privacy policy.

Call (02) 4063 1093 Get a quote