Skip to content

Gas Leak Detection Jesmond

Gas leak detection in Jesmond starts with safety: get people out, call the gas network's emergency line, then ring us. A licensed fitter then tracks the leak down with a detector, pressure tests the section at fault, and quotes the repair before any pipe comes apart. The whole line is retested before your appliances are relit.

Other gas jobs. Cooktop swaps, heater lines and bayonet points are covered under gas fitting, with installs detailed under appliance installation. For drains, hot water and everything else, start with your plumber in Jesmond.

Licensed plumbers and gas fitters · NSW Lic. 359278C

Last updated September 2026

Gas fitter at work on a kitchen oven

What Should You Do If You Smell Gas?

Your safety comes before any plumbing talk. If the smell is strong or sudden:

  • Get people and pets out into the open air straight away.
  • Do not flick switches, use the phone inside or light anything.
  • Turn the gas off at the meter on the way out, if that's safe to do.
  • Once outside, call the gas network's emergency line, and after that, us for the repair.

A brief whiff as a heater fires up may be dust on the burner, but a smell that lingers or builds is never worth guessing about. We would rather attend to nothing than have a household sit on a real leak.

Gas cooktop burner alight
Plumber beside a newly installed continuous-flow gas hot water unit

How Does a Leak Get Found?

Gas slips through joints too small to show water, so the tools do the finding:

  1. 1

    The meter valve is closed first so the line holds still.

  2. 2

    A gas detector is run along the pipe, from the meter to each appliance.

  3. 3

    The suspect section is pressure tested to confirm where gas is escaping.

  4. 4

    The fix is quoted, carried out, and the line is proven sound before relighting.

From the Call to a Relit Appliance

  1. 01

    Ring or send the form

    Call (02) 4063 1093 or use the form to explain the fault. We ask enough to bring the right equipment the first time.

  2. 02

    A fixed price first

    A plumber inspects the job and names a fixed figure up front. Nothing gets started until you give the go-ahead.

  3. 03

    Isolate, trace, name the fix

    We shut the supply off, follow the detector to the leak, and put the figure on the repair before touching a fitting.

  4. 04

    Covered for a year

    Every job carries our 365-day warranty on all work. If something we did isn't right, ring the same number.

What Shapes the Price of a Leak Repair?

The repair price turns on:

  • The leak's location: a perished heater connection is quick work, a buried line under a path is not.
  • Access: pipe hidden inside a wall or beneath the floor means more time than an exposed run.
  • Parts, with a like-for-like join costing less than a replaced section.
  • The hour: night and weekend visits cost more, and you get that rate before we set out.

Two Housing Generations, One Gas Network

Census figures counted 1,162 dwellings here, and area-level approval records show 410 more in the following five years. Post-war brick-veneer and fibro places sit beside fresh apartment infill serving the university at Callaghan. The older houses often still heat on lines run decades ago, while the units turn over tenants who inherit whatever heater the last lease left behind. Both end up on our detector runs, and a smell reported by a new tenant is often the first sign an owner hears of it.

"We had an urgent gas problem that required immediate attention at our home…on a Friday afternoon. … Identified the issue, fixed and tested" Lee

When We're Not the Right Call

The meter and the service pipe coming in from the street belong to the gas network, and a leak there goes straight to their emergency number. Everything inside the boundary, including every appliance and every line in the house, is ours to find and repair. Water leaks are a different trade skill again, and the leak detection page covers those.

Straight Answers on Gas Leaks

What should I do if I smell gas in the house?

Clear the house of people and pets, and don't touch a switch or strike a flame. Ring the gas network's emergency line from somewhere safe, then call us. When the network has the supply under control, we trace the leak, quote the repair and pressure-test the whole line before the heater or cooktop goes back on.

Do you find gas leaks in older Jesmond houses?

Yes. Detectors follow gas along the line even when nothing is visible, and pressure testing confirms the section at fault. Older copper and galvanised runs under post-war houses are common here, and a joint that has wept for years often shows as a smell only in still weather.

Can you check a heater at a rental near the university?

Yes. Tenants ring us direct, and confirmation and pre-arrival messages follow so everyone knows when to expect the van. Any repair cost goes to the landlord or agent for sign-off, and photos and a detailed invoice go back with the finished job.

Do you come out after hours for a gas smell?

Yes. A suspected leak is urgent whatever the hour, and Available 24/7 means a fitter can come out at night or on a public holiday. The after-hours rate is quoted on the phone before anyone is sent.

Need a plumber? Call or send the form

Call (02) 4063 1093 or send the form below. Available 24/7, you see a fixed figure ahead of any work, and every job carries our 365-day warranty on all work.

Call (02) 4063 1093

Request a callback

Leave a name and number and a plumber will ring you back.

We use your details only to call you back about this job. See our privacy policy.

Call (02) 4063 1093 Get a quote